Flexbar Sensing-Saf-Start®
The inexpensive solution to OSHA.
Anti-automatic restart protection without the high cost of magnetic motor starters.
THIS IS A MANDATORY OSHA SAFETY REQUIREMENT
OPERATING CHARACTERISTICS
When a SENSING-SAF-START® is installed on any equipment and there is an electrical power interruption to the equipment, the SENSING-SAF-START® will open the circuit so when the power source is restored,
the SENSING-SAF-START® will prevent the equipment from restarting. The SENSING-SAF-START® will not reset until the equipment switch has been turned "off". There is a sensing circuit within the new SENSING-SAF-START®
that sends a signal up to the equipment switch to see if it is in the "on" position. If the switch is still "on", the SENSING-SAF-START® sounds a warning buzz when the reset button is depressed, and it will not close the circuit
until the equipment switch is turned "off". Only then, the SENSING-SAF-START® will close the circuit , so the equipment will operate again.
- OSHA (29 DFR #1910.213 (b) (3)*)
- NFPA (Electrical Standard for Industrial Machinery, 1997 Edition, Section 8, Protection)
- Drill Presses
- Disc Sanders
- Tool Grinders
- Table Saws
- Small Milling Machines
- Radial Arm Saws
- Cut-Off Machines
- Power Hacksaws
- Band Saws
- Belt Sanders
Now available in extension cord style or hard wire versions:
| 17025 | Short extension cord style. 14" cord on male plug end, 12" cord on female receptacle end. Rated 120 Volts, A.C., 15-amp maximum, 50/60 Hz |
| 17023 | 20" cord on equipment switch end. 8' cord on power end (no plug). Wire directly into disconnect box or install TwistLock Plug. Rated 120-volt, A.C., 18-amp maximum, 50/60 Hz |
| 17024 | 20" cord on equipment switch end. 8' cord on power end (no plug). You must install matching plugs. Rated 200 to 240-volt A.C., 15-amp (single phase) maximum, 50/60 Hz |